Description: The Skelene is a mighty, purple, fireball spitting sea monster. This sea creature has massive spikes on his back. They also have gigantic bright yellow horns on their heads. This  horn glows in the dark. It's like a torch for the Skelene. The fire balls it spits out are only tiny but extremely deadly. One touch and the unlucky victim is engulfed in flames.

Size: The Killer can grow up to at least 7m long and 5m high. When the Killer is born its a massive 3m by 2m.

Age: The Skelene lives for a minimum of  1500 years. The oldest known living Skelene was 1 million years old.

Population:  There is only 5 known Skelene in the wild.

Range: The Skelene only lives in mucky, dirty brown water. The only place that you will find these monsters are in Grimsdon.

Breeding: When a male mates with a female, the female becomes pregnant for 2 days. For the 2 days the female just sits laying wait. The male goes out hunting and stacks loads of food for the babies. They have only 1 a year.

Babies: A newborn is called Sklen.

Behavior: These sea monsters  are deadly to everything. There is not one thing these monsters are afraid of.

Food: They eat a variety of animals, including sharks, fish, humans and other sea creatures. 

Click here to read the interview with Griffin

How to make a rubber band car

Materials And Equipment Needed:
4 training wheels
Super glue
Nails
Screws
1 o-ring
Wood
1 dowel rod
Drill
1 helper (DAD)
Hammer
Screw Driver
Saw


Step One: Get all  the materials needed and line them up. Cut the o-ring so its long and in a line so it's not a round anymore.
 
Step Two: Cut the wood into 4  pieces to the right length, 2 long pieces around 15-20cm. The other two 5cm and attatch 1 wheel to each axle with glue. Cut a dowl rod into 2 which is a bit bigger than the wood you cut.
  

Step Three: Drill holes in the the frame(which is the 2 long pieces of wood you cut) for the axels.
 

Step Four: Assemble the frame. Put the 2 long pieces of wood next to each other. Put the 2 short ones at each end. Then nail the wood together. 
 

Step Five: Put the Axels through the assembled frame.
 

Step Six: Glue the other two wheels on the other side.
 

Step Seven: Hammer  a nail in the front part of the frame and attach the o-ring to to the nail.
 


Step Eight: Test it to see if it works.
 
You make it move my attaching the string on the back rod where the nail is not attached and hold the rubber band on the back rod. Then drive the car backwards until it is all wound up. Let it go and see what happens.