Materials:
Plastic bags
Scissors
Masking tape
Plating skills

Step 1: Gather all of your materials nedded.

Step 2: Cut the top and bottom off your plastic bags. You may throw out what you just cut as you will not use it.

Step 3: Cut a plastic bag into strips the same size. Do this for all of the plastic bags.

Step 4: Get three pieces and tie a knot at the top.

Step 5: Watch this video for how to plait.

Step 6: Tie a knot at the end once you have finished plaiting them.

Step 7: Cut off the ends just before the knot and sticky tape all of the garbage bags together.  

Step 8: Grab a piece of card board and make a estimation how big you would like the base. 

Step 9: Make a massive bundle in your hand. ( not to tight to cut your circulation )

Step 10: Start doing your base. You can do this by going inside your outline and start at one corner and go down then up. As you go along you will need to sticky tape the lines together to hold them. Continue this pattern until your base is done. 

Step 11: Start at one corner and tape the corner so it won't move.  ( not too much tape as you will remove it from the cardboard later )

Step 12: Continue along the outline you created earlier. When you get to a new corner tape it as well.

Step 13: Continue doing this until you have run out of plastic bag rope. Tape anywhere needed.

You have successfully made a plastic bag basket. Have fun filling your basket with lots of different things.

How to make a rubber band car

Materials And Equipment Needed:
4 training wheels
Super glue
Nails
Screws
1 o-ring
Wood
1 dowel rod
Drill
1 helper (DAD)
Hammer
Screw Driver
Saw


Step One: Get all  the materials needed and line them up. Cut the o-ring so its long and in a line so it's not a round anymore.
 
Step Two: Cut the wood into 4  pieces to the right length, 2 long pieces around 15-20cm. The other two 5cm and attatch 1 wheel to each axle with glue. Cut a dowl rod into 2 which is a bit bigger than the wood you cut.
  

Step Three: Drill holes in the the frame(which is the 2 long pieces of wood you cut) for the axels.
 

Step Four: Assemble the frame. Put the 2 long pieces of wood next to each other. Put the 2 short ones at each end. Then nail the wood together. 
 

Step Five: Put the Axels through the assembled frame.
 

Step Six: Glue the other two wheels on the other side.
 

Step Seven: Hammer  a nail in the front part of the frame and attach the o-ring to to the nail.
 


Step Eight: Test it to see if it works.
 
You make it move my attaching the string on the back rod where the nail is not attached and hold the rubber band on the back rod. Then drive the car backwards until it is all wound up. Let it go and see what happens.